Posted by ptfarmer on February 27, 2020 at 22:05:04 from (70.114.32.211):
In Reply to: Porting Cast Iron head posted by Jwilhelm770 on February 26, 2020 at 10:17:00:
Air flow is one thing, but velocity is just as important. I have filled bottom of some ports up to 1/4" with no loss of flow, but the engine made more power because of the increase in port velocity. On the intake ports the increase of velocity helps keep the air/fuel mixed better thus you get better combustion. On an exhaust port the increase in velocity help draw out more spent exhaust gases out of the combustion chamber, and it also helps the intake draw in more air/fuel.
Another thing is how much valve lift you have, most also look at the airflow with the valve at it's maximum opening, and not at flow at half open (remember a valve reaches full open once, but it reaches half open twice).
I mentioned filling the bottom of ports can increase port velocity without reducing flow, but also if you can fill a port floor you are reducing the radius of the turn that air has to flow. The straighter you can make a port the better it works.
Before good aftermarket heads were available for the Ford 351 Cleveland the extreme bend in the exhaust port was a real power killer so what was done back in the day was modifying the exhaust ports with port plates. A section of the exhaust ports were milled away, and new exhaust port plates were put on to straighten out the ports, and it increased flow, and velocity dramatically.
Stock 351C 4V exhaust ports.
351 C 4V with port plates installed (note the ports are now smaller than the stock ports).
Hopefully this shows that it's just not about making ports bigger. A lot goes into cylinder head port work!
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.