Posted by Bruce from Can. on April 01, 2020 at 13:11:05 from (70.52.186.9):
In Reply to: Bale wagon posted by TDJD on April 01, 2020 at 09:21:57:
Buy two 16 foot steel gates for sides, and two gates of whatever width your wagon needs, like 8 foot. Now get a steel plate welded on the end of a 6 foot steel pipe, and bolt it to the floor, front and back, on both sides of the wagon. You may want to fasten more pipe post down the wagon say every 4 feet to give the steel gate extra support. Put gate hinges to the rear of wagon. And be sure to get your end gate with hinges on both ends. So you can hold the three gates together with the hinge pins. Keep the gate up about a foot from the floor, and fasten the gates to the post in whatever way you like, bolt, chain , gear clamps, be creative . Should be light enough that one man can set it up and take down. And if you don’t like it, you can use the gate in a fence, or sell them. Square tube steel gates are very strong.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.