My house is about 200' from a used to be rock road and on the North side of a hill. Previous house, built probably back in the '40's for a number, long since demolished when I bought the place, was between my house and the road. When I built it in '79 there were probably half a dozen cars up and down the road at most, and one being the mail carrier. Back in the early 90's the county put a vehicle counter on the road and it registered 150 per day. On the North slope, the only thing between me and the N. Pole were 5 strands of barbed wire. Something had to be done.
Got out my spade and went around the neighborhood collecting Cedars of the size that I could dig up with my spade-shovel and transplant. Wound up with 160. Planted them around my house area with suitable distancing. Today they are maybe 25 or so ft. tall, branches overlapping. Cars probably number 300 easily as road has been sealed (liquid asphalt and rocks), 2 lane marked, 40 mph speed limit, seldom obeyed, and wind still howls from the North in the winter. But on the house side of all that, is bliss! Well worth the effort and would do it again in a heart beat.
Only problem is when they bloom, like now, lots of pollen and runny nose.....but I was willing to tolerate that when I planted them. However, somebody invented the little 10 mg Loratadine anti-histamine tablet that everybody stocks, with zero side effects, unlike previous like remedies, and life is good.
Cedars love blackland alkaline soils and if you don't keep your pastures mowed or cultivated, you will be the proud owner of a forest of your own.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
