Posted by DavidP, South Wales on April 16, 2020 at 16:12:09 from (92.14.140.61):
In Reply to: Re: Funny thing posted by db4600 on April 16, 2020 at 07:31:11:
Hi, appreciate the concerns about hearing protection but we didn't really think about that much 20 or thirty years ago. I don't think that I've been exposed to really loud noise either driving a tractor or in my workshop. Have got tinnitus now but I can live with it. Going back to your comment about counting the plunger strokes:- whilst on a training course at the New Holland factory in the UK that was part of the training to be able to monitor the throughput of the baler. Around 8 plunger strokes and the baler is working within its capacity. More than that and you're either too slow or wasting capacity. I did this with our Bamford, MF 20 and NH 274 balers. If I happen to hear a baler now I count the strokes between knotter cycles. DavidP, South Wales
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
