Posted by JMOR on May 21, 2020 at 16:24:58 from (76.187.207.141):
In Reply to: Ford 860 Hydraulics posted by Hemmjo on May 21, 2020 at 04:59:22:
Quoting Removed, click Modern View to see
Ford 860 isn't a Ford 8N. See that here all the time, where someone just assumes that whatever their experience is will fit whatever the other guy has. Done it myself with front /side mount distributors on 8Ns. Doesn't always work out. What they do have in common in this area is that lever CCW is Position control and CW is Draft control. Also, when moving the lever, if in the direction where you feel the compressing of a spring, then you are moving to Draft control , whereas if you move in direction where you feel a spring releasing and lever tries to jump out of your fingers, then you are moving to Position control.
...and on his 860, just remember the "D"s......lever pointing down is for ground engaging implements (Draft control)
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
