Posted by John T on May 27, 2020 at 13:35:24 from (45.16.200.171):
In Reply to: Hmmmm posted by Grandpa love on May 27, 2020 at 11:41:43:
The plugs obviously appear ripe for fouling, and those anti foulers (as often happens in a poor engine) aren't working.
Often a flat black dry colored even sooty coating is due to gas fouling from over rich or other conditions
Often an uneven looking, maybe more wet looking, maybe more shiny looking coating is due to oil fouling
Things that can help reduce fouling UNLESS the engine is a bad oil burner and needs rings and/or valve guides etc
1) Get and keep the operating temp up to 180 and more. Perhaps thermostats or air curtains or air restrictions 2) Use a hotter spark plug 3) Don't run the carb any richer then necessary 4) Avoid long idle periods WORK THE ENGINE 5) Insure the ignition is well tuned yielding a good strong hot blue spark, not a faint thin wimpy yellow
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
