Posted by Bruce from Can. on May 27, 2020 at 18:03:36 from (70.52.186.9):
Had my Kubota baler for 4 seasons, gosh how the time goes by. Anyway turned it in on a new one , just the same really, though the monitor is different. This baler I traded should be a decent machine for someone. I don’t make much over 1,500 bales a year, but most are wet haylage bales. And getting hay rolled up when I was want it done is critical to making good feed for my dairy cows. And I don’t want to be fixing when I should be baling. I know some will have critical opinions about my decision, but I reason that there is a cost attached to owning equipment. I used to pay $10.00 per bale to get wet bales made, and it was a pain in the backside getting the guy to bale my hay, when a dozen others wanted him too. And doing 1,000 wet bales each year at 10 bucks each, ten grand slides through my fingers. Might sound crazy to some I am sure, but late model balers that are not worn out , fetch a good price. And it doesn’t really cost that much per bale to keep a new machine. Just ties up capital.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
