Posted by 330 Standard on June 08, 2020 at 07:02:08 from (198.70.164.145):
OK here's one I need some help with. I am not a math person nor am I an engineer person so I am not good at this which is why I am reaching out. I purchased a homemade Unstyled JD A cutaway that the previous owner designed to run off the PTO of another tractor backed up to it. It is really very well done but I want to convert it to drive with an electric 110/120v motor for a number of reasons the first being eliminate the noise of the 2nd running tractor and more control. Currently it is set up where the drive tractor pto shaft drives a large sprocket with a chain driving a smaller sprocket mounted on the PTO of the cutaway. I don't mind hooking the electric motor up directly to the large sprocket instead of directly on the PTO sprocket but I don't know anything about how much torque I'd need etc. I looked up engine speed of a running tractor and its 975 that would put the PTO at 540 normally. I have seen this cutaway running before and the engine did turn slowly with the drive tractor running at what I'd call pto speed. Does anybody have any suggestions on where to purchase and what size, type motor I could get and hook up directly to the PTO and get the speed down to where the motor on the unstyled JD A cutaway turns very slowly so folks can watch the pistons, valves etc move slowly. I think this will be very cool to take to the shows and even some of our school ag mech classes but I think the electric motor with a simple on off switch would be a lot safer. Thanks in advance for the help and I look forward to see what suggestions the community comes up with.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoring a John Deere 2010 Diesel Tractor - by Jim Nielsen. Following seven years working in California's Silicon Valley, my wife, baby son and I moved back to Australia to retire. We bought a small 'farm' of about 50 acres near Bendigo, in the state of Victoria. I soon found that it would be very useful to have a tractor around the place for things such as grading our long drive and brush-hogging the fields. I was also embarking on planting 1000 eucalyptus trees, and hence I would need a ripper, small disk plow, sprayer etc. to get these things accompli
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
