Posted by MtMan on June 08, 2020 at 19:32:16 from (50.107.165.228):
In Reply to: Busy day posted by Grandpa love on June 08, 2020 at 18:21:46:
I was using my 1948 Cub with a sickle mower and I assume the mower was originally purchased the same time. Any how, I lost the rear heel plate off my sickle bar. I didn't realize it until I was done mowing and put the cutter bar in travel position. I notice the knife section had falling down because this heel plate is what keeps it up. I happened to think that I have an old horse drawn mowing machine up in the barn. I checked and the part looked the same and measure the same. The horse mower is IH also. It could be about 100 years old. When I was trying to get it off, I figured it might have never been off. It was hard to get off, but when I did and cleaned it up it fit perfect. My niece found my lost piece in the 2 acre piece that I was mowing. She didn't know that I lost it. She came and asked me if I had lost a piece off my tractor or mower. Well surprising enough they both had the same casting number on them . I feel very lucky to have both mowers in working order again.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
