Posted by Janicholson on July 14, 2020 at 08:31:13 from (24.240.46.228):
In Reply to: David Brown 780 posted by larry63 on July 14, 2020 at 08:20:44:
If you have a removable plate over the lifter gallery, the stuck lifter can be freed up by cleaning the exposed part of it, then polishing that part with 600 grit paper, Just remove rust. Then using PB Blaster, or liquid wrench, soak it some. Turn the engine so that lifter is not being pushed by the cam, and tap it down ward. Turn the engine so it comes up again, and repeat 5 times or so. Eventually it will free up enough to be pulled out and cleaned up, along with the gallery hole. The bent pushrod is from a stuck valve on that cylinder. It may be unstuck now, but it was stuck enough to bend the pushrod, so it might need to be freed as well. Let us know. Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An AC Model M Crawler - by Anthony West. Neil Atkins is a man in his late thirties, a mild and patient character who talks fondly of his farming heritage. He farms around a hundred and fifty acres of arable land, in a village called Southam, located just outside Leamington Spa in Warwickshire. The soil is a rich dark brown and is well looked after. unlike some areas in the midlands it is also fairly flat, broken only by hedgerows and the occasional valley and brook. A copse of wildbreaking silver birch and oak trees surround the top si
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
