If you were talking about a Chevy, I could give you a lot of advice. With a Ford, I have to agree with those who said it would cost 'way more than the truck is worth.
Back in the 1980s and early 1990s, I made good money rebuilding rusty Chevy and GMC pickups. I wouldn't touch Fords because they were too hard to work on.
On Chevys, there were ample aftermarket fenders, door shells, box sides reasonably priced. Parts always seemed to be higher for Fords. Plus Fords were far more labor intensive. Case in point: to do cab corners properly the box needs to be taken loose and either raised or moved back. Chevys had through bolts holding the box, and if they were rusted you could just torch them off. Fords had bolts that bolted "blind" from underneath, and would either twist off or the blind nut would turn in the box. Either situation increased labor exponentially.
Then, Chevy boxes were bolted together, and complete new box sides were only a couple hundred bucks each, even OEM, so if the box side was bad enough you simply bolted on a new one. Ford boxes were welded together, again increasing labor enormously.
On a Chevy, with new aftermarket fenders at $50 each and door shells less than $100, you almost automatically just pitched the old ones and went with new. Again, Ford parts weren't that cheap and were more labor intensive.
I counted once and found I'd done about 67 Chevy and GMC pickups and full sized Blazers over the years. Some customer owned, some I bought, rebuilt, and resold. I did one Ford for a friend.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
