I moved my Wagner from an 8N to an 860 recently. I faced the same issue, and just called the folks here at yesterdays tractors and explained my situation. They provided the right stuff, I had to buy the spline hub for the crank nose, and also the shaft.
I had to shorten the shaft about 2". You will likely also note that the rear plates which mounts to the fender flange bracket is different. The 860, and I presume the 641 are a longer wheelbase than the 8N. I simply made a pair of new 90deg angle braces for under the fender, to the mount plate on the Wager(vertical plates).
If the 641 front is similar to the 860, don't even try to get the new hub on the crank without removing all the tin, and the radiator. It's a very tight, and awkward fit. If you are able to get the hub in there, getting any of the bolts and locknuts on is nearly impossible. I fiddled with it for 90 min before just taking it all off and working on it with easy access to the front pulley.
Also, if you have power steering pump driven off the crankshaft, you will likely have to get 1/4" longer bolts for the snout. the hub will only allow 2 threads to catch with a double pulley on the front. If you already have a hub on their, you're lucky, and only need the new shaft. Count the splines on the hub before you order it here.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
