Posted by Northvale PA on July 27, 2020 at 18:42:52 from (24.112.141.217):
In Reply to: Cutting Hay In Sask posted by rusty6 on July 26, 2020 at 23:17:16:
Ok. So, I use to run a NH 469. Top speed was 4th gear on my JD 4020, doing thinner 3rd cut. Now, I run a NI 5209 discbine in 5th gear. I can go in 6th but normally do not. I want the hay cut and crimped well. But in any case, watching your video is like watching farm work in slow motion. Seriously, I could not go back to mowing with a haybine at such a slow speed. Have you thought about trading up? Ever use one? I envied those guys for years. It is enjoyable to go around a field quickly and finish in a reasonable amount of time. I almost always mow in the evening. Years ago I dreaded 1st cut hay. No problem now.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
