Posted by D7fever on August 21, 2020 at 16:34:48 from (107.242.117.60):
In Reply to: 2n eating coils? posted by frysinger on August 21, 2020 at 13:32:51:
Probably works the same as a Ford car of that era. There is a resistor in line with the hot wire to the coil, reduces the voltage to around 3.5 volts to the coil. That is necessary if you are using a 6 volt FORD coil. You can use an aftermarket conventional type 6 volt coil and eliminate the resistor. How ever if the coil is the type that is special and mounts to the top of the distributor, it is the FORD coil. An adaptor can be made , or maybe purchased that can be mounted to the distributor where the coil mounts and a conventional 6 volt coil can be used. the resistor can be purchased at one of the V8 ford supply outfits, like Mac's, Bob Drake , Etc. good luck.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
