Posted by DaleM on September 23, 2020 at 12:18:38 from (73.146.237.229):
Tach
The tachometer isn't working. Removing the cable at the tach and starting the engine, the cable wasn't turning and I couldn't get any sense of mechanical engagement by pushing and jiggling the exposed cable end either. I pulled the cable out and it has a normal square end with a finished tip.
I think it's driving off the camshaft. It looks like it wouldn't be a big deal to pull it apart. Before I do, though, I'm wondering if there's anything else I should check or likely causes. I'm considering damaged drive connector or previous cable remnant. Is a damaged drive difficult or expensive to fix?
Before putting the control console back together. I think I should lubricate and test the tach, but haven't found a procedure or know which lubricant to use.
Work Light Cable
This wire is exposed and vulnerable looking. I found a tractor restoration article where it was covered with a tough look dark sheathing. Does anyone know where I can find this material?
I untaped and cleaned the engine harness. I intend to use regular split plastic wire loom there.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.