Allow yourself plenty of time, and don't expect to have the whole crew for the whole time.
A day to do the tear-off, including pulling all the old nails. (If you don't pull the nails, you'll wreck a few shingles when your nailer hits old nails.) A day to prep the roof: Replace bad sheathing or completely re-sheath, underlayment and drip edge. Two days to lay down the shingles. Longer if there are valleys or other complications.
Sure, you can do it MUCH FASTER than that with four guys, but the results won't be pretty. Take your time and do it right. Make sure the sheathing is in good shape; otherwise put down a layer of of 7/16" OSB over it. Put down "ice dam" underlayment if your roof is subject to ice dams. Lay out vertical chalk lines to line up the shingles. If you put down the felt straight, you can use the lines on it to keep the shingles straight; otherwise use horizontal chalk lines.
You will save a lot of time if you use "architectural" shingles rather than three-tab. They're bigger and you don't have to be as careful as with three-tabs when you install them for them to look good.
Don't get in a hurry with those roofing nailers. Amateurs and many "professional" roofers will put the nails too high and miss the shingle under the one being nailed. If this happens, you won't know until the first storm comes.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
