-Smaller bore master will marginally increase pressure, if the truck has single piston calipers the decrease in volume should not be an issue.
-Thoroughly manual bleeding of the system with someone else running the pedal for you will eliminate the chance of any air and it will give you a real good idea of what you have for flow and pressure at each wheel.
-Proper routing of lines to master cylinder and combination valve along with proper line size.
Front port is not always for front brakes.
-For the time it would take I would pull the drums, inspect and measure them, check everything over and adjust properly.
-Wheel cylinders can have the same casting number yet different sized bores be it from factory or from a rebuild.
-Does the wheel cylinder bore match what stock for the year would be?
Is one side of a cylinder stuck?
-Is there a residual valve for the drum brakes?
-Is the combination valve holding back the application of the drum brakes too much?
A big difference in a valve for a fiberglass body vette and one from a 9 foot longhorn.
-The setup you have if working properly would seem to be more than adequate to cause the front calipers to lock up solid if the rears were not functioning.
-Pedal travel, pushrod length and geometry.
-I have done a lot of brake conversions on equipment over the years and in general I would expect to see 700-900 PSI on manual brakes and 1100-1400 Psi on vac boot power brakes.
-9 out of 10 times when I resorted to checking actual line pressure the problem was not the sizing of the components it was either air, geometry, condition of components, restriction, blockage.
-A heavy foot should be able to stop that truck without any boost if everything is right.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.