Yes, it is a D10 as you mention. Good call on the fuel line coming to the carb, we will need to check that next.
I think I'll try to get the float set back to where I found it, which would allow about 1/4" higher fuel level in the bowl before the needle valve closes off the inlet. That would put the float at about 1 and 3/4" which is further away from your manuals spec, not closer to it.
Let me clarify; the measurement was from the top half (turned upside down) of the carbs center body flange with the gasket sitting on it, to the bottom of the float body, (or top since its sitting upside down at the time of measurement) not including the seam thickness around the float. The float seam is maybe 1/16" thick and the gasket thickness is maybe 1/32".
I'm not familiar with how these D01 carbs work, so what is the danger of having too high a fuel level in the bowl ? Will fuel ooze out of the gasket where the 2 body parts meet?
Someone mentioned 'updraft' flow, what difference does that make? I see there's a big venturi in the middle of the carb body, but not sure how the fuel level interacts with that. Need some insights on this...
I'm definitely not seeing anything in that small hole at the bottom of the carb intake throat, its wide open. Guess I need some 'felt' to stuff in that hole
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
