Posted by Steve@Advance on November 22, 2020 at 06:51:13 from (66.169.147.211):
In Reply to: belt power equipment? posted by swindave on November 22, 2020 at 05:26:39:
I've never run one either, watched it done at tractor shows.
It works well if the operators know what they are doing...
I've maintained a lot of conveyor belts. Most run with no problem, but some that don't have the crowned rollers area constant battle to keep them tracking in the middle.
One place had a multi bank drill press with flat belts. Constant problems! To keep the belt from slipping it had to be tight. But run it too tight and the lacing would pull out!
Belt drive was how everything was run in the old days before electric motors. Entire factories ran off a common shaft with a belt for each machine.
There is a cotton gin museum near here, it is set up like that. They start up the old Bessemer diesel and run it once a year.
What a nightmare that place would have been! Hundreds of belts, shafts, pulleys... Hot and nasty! They said working the night shift was more desirable because of the heat. Fire was a constant threat. The dust and lint were highly flammable. The belts generated static, a hot bearing could bring disaster!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
