If the muffler is clogged, the oil ratio is probably too rich, or the quality of oil is low, don't use marine/outboard oil either. Muffler clogging is really a thing of the past, back when oil quality was low and they used rich oil ratio's to compensate low quality of oil. With modern, higher quality oils and a mix ratio of 50:1, it seems almost impossible this would happen. Fuel left in the saw will evaporate, leaving the oil behind, same thing can happen in a fuel can too. This will make the oil ratio too rich along with gas going stale.
Cleanings options:
Take muffler off, use a torch to cook the carbon/oil to ash, or throw in a fire.
Soak in a strong solvent or carb cleaner, use pics or small screwdriver to scrape gunk out.
Then use compressed air and a blow gun for final cleaning.
This might help in starting. Prime bulb 5-7 times, pull choke lever out (don't touch throttle lever) try to start it (1-3 pulls or, 5 pulls max if real cold). If it sounds like it tried to start, stop pulling, and push the choke lever back in (don't touch throttle), now pull to start. Let engine run at fast idle for 20-30secs, hit throttle to return to idle. My homelite saws always need the choke lever pulled out and pushed back in unless the engine is hot and recently shut off.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
