Posted by Crazy Horse on November 29, 2020 at 15:28:36 from (108.173.201.233):
In Reply to: Re: Thread sealer posted by Farmer Rock on November 29, 2020 at 15:17:19:
FR .... this below is from a discussion forum on a web search .... sounds like the color is marker as to the product's thickness in some cases and it's actual chemical makeup in others. At least from what this says ....
"The colors mean something, but the meaning has changed over the years so some info may be old. The CURRENT standard is:
White = single density tape and is ONLY good for small fittings up to 3/8 in. pipe. Most people are unaware of this. "Double Density" tape used to come in white as well, but because that could be used for larger pipes, it was impossible for inspectors to know if the white tape used on 1/2" and larger pipe was in fact double density, so they stopped making it.
Yellow = double density, required for natural gas (methane) piping 1/2" to 2" dia. pipe. In many jurisdictions you MUST use double density tape on gas piping, so inspectors will look for yellow.
Pink = triple density, required for NPT threads 1/2" to 2". Again, most people are unaware of this change and hardware stores rarely sell it for the DIY market, but if you are going to get an inspection, this is what you must use now. This is also good for gasoline and propane lines.
There is also green for medical gasses (oil free tape) and gray / silver for use with stainless steel and aluminum pipe (has anti-seizing compounds embedded in the tape).
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.