Posted by super99 on December 02, 2020 at 05:21:44 from (184.20.245.17):
In Reply to: Farmall 400 questions posted by super99 on December 01, 2020 at 18:41:15:
I have done a compression test with all of the plugs out, crank it 10 times and get right at 100+s compression on all cylinders, didn't think to add oil and recheck. I'll do that. I put non foulers on all spark plugs and it will start missing from fouled plugs in less than an hour run time. I haven't check the valves yet, I'll do that after I get it cleaned up and it warms up a little bit. It has add on power steering that leaks bad around the torque generator so the motor is covered with oil. It's really cold blooded, when I get the carb set to where it runs halfway decent, it smokes black like it is running too rich. The shaft in the distributor was sloppy, so I replaced the distributor and that helped starting but I'm still not happy with how it runs. I have put off doing anything with it for years, but now it's time to give the old girl some lovin.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
