Hello Troy welcome to YT! Those Belarus tractors are assembled a bit odd compared to US convention. I generally don’t recommend cobbling an electrical system to something other than as originally designed but in this case it seems proper because the lights and heater blower are the biggest load you have on a tractor if those are all coming back on line by connecting one fuse then I would say that is to much to expect out of one fuse. There could also be problem that was caused when circuits got hot insulation melted and two circuits now are unintentionally connected. You will need a wiring diagram to determine that or following suspect melted wires back beyond the fuse block connections to see if this is an issue. If all else fails I would say it would be proper to feed the lights and heater blower from new sources you create. If you go this route I would recommend making the connection at the positive battery cable connection at the starter if it is fairly easy to access instead of the battery to stay away from the corrosion from battery acid. Place a fuse holder there as I show in the link and I would recommend the one with 10 gauge leads but should be okay to use 12 ga wire for your added circuit feeds. Place it there so if something shorts out in the future along the run of the wire it blows the fuse instead of possibly starting a fire. I would run a 20 amp fuse one for the lights an one for the blower. Then if needed bump the amps up to 25 if it blows the 20 maybe even 30 but that will heat up a 12 wire pretty good before it blows. You will need to run these feeds direct to the switches and disconnect the original feeds or you will still be cross feeding between the circuits if the are all originally hooked together. To lessen any possible confusion the loop of wire on the example fuse holder is cut to turn it into two leads. Kind of long but hope this helps.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
