Posted by Jim.ME on December 19, 2020 at 13:05:21 from (67.242.178.40):
In Reply to: Micrometer reading 101 posted by svcummins on December 18, 2020 at 13:28:20:
Quoting Removed, click Modern View to see
Thank you for clearing this up, the small marks are each 1/2 thousandth as I thought. The packaging may say graduated in .001" but the thimble of the one you have is graduated on .0005" increments. So your reading that started this was about .6985", .0015 less than .700. The angle of your picture may be throwing that reading off a bit as compared to looking at it square on, in hand.
As for the .010" difference between the caliper and mic, it could be several things; calibrations may be off, piece you were measuring might be out of round, operator "feel" was likely different, changing temperature, for somethings. Even the temperature from your hand can make a difference. The calibration shop I take things to won't do a calibration until the tool sets in their lab for 24 hours so it is the same temp as the calibration gear.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Purchaser Checklist - by Greg Sheppard. Pound for pound the 550 is better than anything I've seen. It has great power for its size and can really hunker down and lug. Classified as a 3-bottom plow depending on soil conditions. I personally don't think it can be beat for a utility tractor in the 40 HP range. They are extremely thrifty on fuel, at least my DSL is. Most drive train parts are fairly easy to get. Sheet metal is probably the hardest thing to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
