Over size in MI gets interesting since the state does not check the bridge clearance before issuing the permits. they just issue the permit. You are supposed to knoe the clearances before hand. got into that with A load into Charlotte one time. The permit service I normally used would farm over height loads to Jack's permits. He has all the old bridge clearances for the state plus all the drivers and pilot cars that tell him about changes in them. I got a load from CNH that was through the same company just different office they didn't use Jacks for the Mi permit and I'm 14'4" With a 13'9" bridge. Let the air down on the truck and trailer. Then let the tires flat on the tractor to get under. Then air tires up on side of road afterwards. But wait only 2 will take air the other 2 lost the beads so have to go in flat. Not much you can do. Didn't much for excitement in other states. Never had a problem with running out of time on permits. Though did get into a deal where the machine was wider than the dimensions I was told and had to get into pilot car for the rest of the trip from TX-OK line up to MO. The 18or 20-38 tires are flotation tires for those deere sprayers and add about 6 inches in width to the load. 12 foot gets the limit before the cars start.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
