Posted by bc on February 11, 2021 at 12:51:51 from (24.255.129.137):
In Reply to: Burn barrels WAAAAAY OT posted by Fred Werring on February 11, 2021 at 07:10:10:
I've read the newspaper reports way back when about the explosions from cutting open oil drums. Have a few now I want to make a stove for the barn. Been debating on whether a grinder would be the same as a torch. Can do the hammer and chisel but want to use the cut off piece as a door on hinges. Put some firebrick and sand in the bottom and figure out how to have a cleanout. Figure the bung hole could be a vent but not sure if it should be at the top or bottom with the barrel on its side.
Most big cities here in KS have banned burn barrels. Some of them banned barrels when the trash haulers unionized and wouldn't lift 55 gallon drums. Burn barrel and/or pit is just fine in the county but you are supposed to call it in to 911 to let them know whether you are burning in a barrel, pit, wood pile, or pasture. Now they have county wide pickup with their own containers so not too many people burn anymore.
Got another idea here. Have a small creek crossing I've been wanting to build and put in pipe but it is expensive. Guess I could put some open ended barrels together since those are cheap and bigger than pipe I can buy.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
