Posted by sparepartsTN on February 11, 2021 at 16:02:15 from (74.230.170.174):
In Reply to: nna steering posted by RICKM1417 on February 10, 2021 at 03:16:52:
I didn't know the answer so I looked in the manuals. The steering box doesn't have a drain, the repair manual says to drain out the oil when rebuilding, after it is out of the tractor. There is a 1 1/4" expansion plug on the bottom of the steering box but the parts manual doesn't show an exact location. To add oil there is a square pipe plug on the front of the steering box where the steering tube goes in, to fill use extreme pressure gear lubricant: 80 wt in winter and 90 wt in summer, fill to top. I use gear oil in mine. That info comes from the Ford shop manual, the Ford operators manual says to use "grade "O" grease with a suction gun and fill to the level of the filler plug hole". Confused yet? The lubrication maintenance says to check and fill steering box through the square pipe plug, if needed, every 100 hours. The only opening for the water to get in would be down the steering tube under the steering wheel, I would advise keeping that area covered if it lives outside. Good luck and welcome to the site.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
