Posted by DoubleO7 on February 19, 2021 at 07:18:05 from (75.115.42.50):
In Reply to: Texas houses posted by cjunrau on February 18, 2021 at 11:25:10:
Texasmark1,
"if you don't get a permit for your construction project, after all the necessary inspections, you don't get a green tag on your (empty) utility power box."
how do you get inspections done if you do not have a permit to start the project???
Here in , Florida every little thing you want to build on your property has to be permitted. Even a yard shed that gets delivered by a pickup from the big box store.
All new housing here for decades is built on slab or on pilings elevating first floor 10 to 12 feet or more depending on location relative to the coast.
Many but not all slab homes have overhead plumbing. With an effort to have all drain work on the perimeter of the slab.
That way you reduce the need of busting a trench thru the house in the future to make repairs to drain lines.
Supply piping over head thru the attic space under the insulation.
Insulation is on par with best practices used up north.
Does not matter if your battling against extreme or cold, stopping the passage of btu's thru the building envelope is the goal.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
