Posted by MeAnthony on February 20, 2021 at 07:29:57 from (172.58.121.210):
In Reply to: Hauling round bales posted by svcummins on February 20, 2021 at 00:41:13:
I lived in Oklahoma in the late '90s. It was pretty common to see a pickup with flatbed, flatbed had an arm along each side, pivot pin at the rear; mounted vertically on other end of arm was a spiked disc, pointing inward. Back up to a bale, arms fold out, spiked discs grab the ends of the bale, pick up and put on the truck. Depending on the size of flatbed and bale, you could potentially have 2 bales on the bed and carry a 3rd on the extended lift arms. Never seen one here in south central Michigan, wonder why not, sure seems handy. Maybe someone should become a dealer? Also frequently wondered why some farmer hasn't re-engineered their snowplow mount setup to haul round bales. Again, sure seems handy but I don't know the forces, hydraulic requirements, etc that would be involved.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
