Just realized I'm wrong on my sizes cause at Oreillys last night I was screwing the sender into a bolt gauge which was 3/8" size then the Oreillys guy said something about a 3/8" pipe tap. Technically I think the oil sender is an 1/8" so I would need a 1/8" pipe tap and the block drain valve was 1/4" British so I need a 1/4" tap.
I have an adapter for the block drain but I just as well tap it out. I ran a 1/4" left hand drill into the old block drain and it just cut a little leaving quite a bit around it. Think I could carefully drill out that aluminum. The block drain is about half way down just under the head but above the cam which is above the crank. It is probably only about 3 inches below the present sender. Guess as long as I know it could be a little low, I can deal with that. Either way, when the heat starts to rise above normal, I'll know it.
Bob, I haven't ever used McMaster Carr. First go to has always been Amazing and fleabag.
That darn oil gauge came with this 1/8" plastic line with compression fittings. The male end sticking out of the gauge takes a compression nut thread. I'd like to go bigger so I can use copper tubing. Oreillys and Ace didn't have it. Now I see if I make a road trip I can get it at Napa.
Good thing my labor is cheap as I've spend more time on this little project than it should take for an American tractor.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
