Posted by Texasmark1 on March 19, 2021 at 03:28:19 from (172.242.4.238):
In Reply to: Re: detroit diesel? posted by Destroked 450 on March 18, 2021 at 19:40:51:
Your comment about river barges....I worked the last 2 summers in high school on the Intercoastal, up the Miss. to Vicksburg, MS, and swamps of Louisiana on a couple of tugs, first year as a deck hand and second year as a cook since I could cook and nobody else on board could...upped my pay a buck a day...from $15 to 16, room and board furnish...great wages back in '58-'59. We ran barge traffic of all sorts and running the oil rigs back up the Mermentau River in Louisiana was the most work....wasn't half a mile of straight river the whole way. We'd usually come in with 4 ea 135' oil barges as I recall and have to S them the whole way.....but, for a high school kid and summer activity, I loved it!!!!
The first boat was the Atlas and had a 6 cyl. monster with exposed pushrods and valve train making a clackety clack noise and 400 HP at it's 900-1000 RPM running speed. The second boat, the Lone Star, had a V-12 cylinder GM 4 stroke putting out 1000 HP as I recall. The GM was smooth as silk and very quiet for an engine that had side panels and the grease monkeys would take a side panel off and crawl into the engine for repairs some times.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
