Posted by Tech 7 on March 24, 2021 at 15:30:12 from (67.220.34.111):
In Reply to: Coming to a Cross Road posted by Bruce from Can. on March 24, 2021 at 07:03:08:
It is a dilemma and I have no answers or advice. I worked for a dairy/mixed farm operation for almost 10 years. When I decided to leave the cows did too. Still feel badly about that and feel that I tipped my bosses hand. Hanging up milkers for the last time was like a funeral. Brother in law had a partnership with his brother and had milked together for their entire lives. The city was closing in and every decision for 25 years revolved around how long will we be here?. They split the herd in half, J bought a farm 40 miles away, built a new freestall barn and started over....when he was close to 50. Retirement wasn't considered. Today he and his son milk about 75. Yup a small herd by current standards. A neighbour here added a freestall type barn (sand pack floor I believe) to turn cows into after milking in the original tie stall barn. It seems like a lesser investment in some ways but all things cost
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
