$100 for a R Minneapolis Moline about a 48. Had been hot and would barely run. Smoked a lot and fouled plugs and had a stuck valve or two and knocked bad. This was 1966 I had just bought a house and 80 acres for 16500. Good house with a basement. House wasn't completely finished on inside. Still live in it. I worked at a MM dealership. He had just bought out another dealer and I was helping move their parts to our store. I found everything to overhaul engine. Including new pistons. There was a new crank maybe 2. Parts were free. But decided didn't need it. Just needed a new front main bearing. It was a ball bearing. R's just had 2 main bearings. My new wife plowed with it while I was at work, with a 2 bottom AC trip rope plow. Wish I could find the picture. Dad felt sorry for her and loaned us a 801 Ford and 3 bottom mounted plow. It would plow more than twice as much as the R would.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
