I grew up on the cultivator. JD. 60 four row front mount. There's a knack to it for sure. Set the shovels close, replace shovels if worn, Set each gang perfect depth, set each shovel on gang perfect depth, adjust shields just right according to crop height, change as needed, drive right speed to cover weeds but not crop, stay awake, readjust all those things when you go to next field. But we really had clean fields. Then when we wore that cultivator out Pa bought a rear mount 4 row and put it behind the 700 Case. I hated cultivating with the front mount but I really hated cultivating with the rear mount. Cultivate the corn 4 times if possible and the beans 3 times. Pa would start cultivating around 7 am. then I would take over around 10. Stop for dinner then I would go out until about 4. Then Pa would take over and stop for supper then go back out until dark. We had about 250 acres of row crops so we really had to keep that cultivator going. I still cultivate a little of my own and then the 80 acres of organics I custom farm for the neighbor but I have a 12 row so when I make a couple rounds, I'm way over here already. Lots different from growing up with the 4 row.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
