On a 2000 you should have a single lever with a smaller selector lever to allow you to select Draft or Position control. The 2600 has two seperate levers for these functions.
If you have a 2000, the shaft from the lever to the control valve linkage can seize in the tube. As already suggested you will need to remove the lever and quadrant, removing the ram cylinder and the control linkage will allow you enough room to work to free things off.
The other are you may have a seizure is in the control valve. This is the valve at the top of the ram cylinder if you have the lift off and laying on its back. If you disconnect the linkage by removing the pin and short, adjustable link that goes into the valve it will enable you to tell whether it is the linkage or the valve.
I have had this problem before and sorted out a number for customers, try not to use excessive force especially on the valve itself as this is a precision made item and easy to mess up. If it has rust on it, do not use any form of abrasive to clean it, use a good quality metal polish.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
