What is the condition of the rubber boot on the rod that sticks out of the right brake? Does it have a hole big enough for a mouse to go through? If so you need to pull the bolts loose on the cover and reveal the mouse nest in there. That is the only thing that I could think of that would lock up one of those brakes that tight in that short of time. If that IS NOT found to be the problem more investigating is needed. I am sorry, but those picture tells me zero, they may be clear as day to you....but I am not there. You need to take a picture of the gap between the wheel and fender of each side standing straight behind the gap so we can see the whole fender top to bottom. Then one standing squarely behind the tractor so we can see the full height of both wheels. Secondly, it would be ideal if you had an 8ft 2x4 you could lean up against the tires and set it vertically level..as in hood the level on it.. may require wire or bungee to hold the top. Take a picture of that for both sides so we can see the full height of the wheels. If it is actually something in the rear end you can pull the pivot block for the top 3 point link and look in there for what the cause might be. I will place a link here to the CNHI parts page for your tractor, in section 07-32, which is on the 2nd page of the list, shows the rear axle drive layout. Shaft 10 has the brake on the outer end. It drives the Bull gear 20 which is on the inside end of the wheel axle shaft. The bull gear and axle assembly is in section 07-33.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoring a John Deere 2010 Diesel Tractor - by Jim Nielsen. Following seven years working in California's Silicon Valley, my wife, baby son and I moved back to Australia to retire. We bought a small 'farm' of about 50 acres near Bendigo, in the state of Victoria. I soon found that it would be very useful to have a tractor around the place for things such as grading our long drive and brush-hogging the fields. I was also embarking on planting 1000 eucalyptus trees, and hence I would need a ripper, small disk plow, sprayer etc. to get these things accompli
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
