Posted by John T on June 01, 2021 at 17:34:15 from (45.16.200.171):
In Reply to: Why do floats stick posted by SDE on June 01, 2021 at 10:47:27:
Gum and varnish or corrosion or foreign material are possible causes of sticking needle valves, maybe from setting too long, or old stale gas etc. For long term storage Ive had good luck using Sta Bil and a bit of low ash combustible two cycle engine oil in with the gas for long term storage.
Obviously if there's no gas left in the carb bowl and you turn off the gas to run till the engine dies (or drain the bowl manually) the float will drop down and the needle valve will be open, but if it gets stuck open/down and fails to rise and close, the carb will flood when the gas is turned back on grrrrrrrrrrr Soooooooooooooo if you drain the carb or turn off the gas so the float drops and the needle valve sits there OPEN just hope it doesn't gum/varnish stick and reman open when you turn the gas back on !!!!!!!!!!!!!!
Try Sta Bil and two cycle oil that can help sticking needle valves
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
