Posted by caterpillar guy on July 02, 2021 at 03:31:44 from (47.26.95.42):
In Reply to: Found a IH 806 posted by sonnythomas on June 30, 2021 at 13:45:02:
If the line goes from the side of the pump on a fitting to the bottom and across to the other side you have an IH RD pump. And no that line is exactly right there is a line from the filters to the other side of that fitting. The low pressure pump is on the back end of the injection pump. Will have a row of small bolts around the outside edge. They are probably 12 point heads. Simplest pum made for them. Easy to pull and Expensive to fix. They quit making them before they quit making the tractor. The other pump they used is no better since it is a Roosa-Master. I doubt it is the lines or the pump. You do need to pull the throttle wide open to start and slow down quickly as it starts. Will idle fine. I would try bleeding it and check fuel for junk in it. Also did somebody happen to turn off the fuel by some chance. with good filters and air out it should come to life really easy. Get back to me if you have more problems with it. I just swapped mine out this spring.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
