Posted by caterpillar guy on July 28, 2021 at 08:01:52 from (47.26.95.42):
In Reply to: Brake pad thoughts? posted by Olliejunkie on July 27, 2021 at 09:35:29:
I don't see how cast iron warps since it is a fairly stable metal to begin with. As for disc brakes I have more one sided wear from stuck calipers than anything and hate disc brakes. Drums work better for me with less maintenance. Put one set of shoes on in 200,000 miles and changed a few sets of those foolish pads on the same vehicle. Semi went 700,000 on the first set of shoes first 3 years was driving Chicago traffic from Detroit to Halstead street exit off I-80. I used to run about 150,000 miles a year back then. Containers had notoriously poor brakes on them. So truck did most of the work stopping then. OTR work I run over most all of the western mountains even on a lot of the old 2 lanes out there like across US-12 and up US-95 from down by Payette Id to Lewiston or I-90. Lots of hills and steep grades in CO too. Like over La Veta pass on US-160 from Walsenburg to Fort Garland. West is easier than east there.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Purchaser Checklist - by Greg Sheppard. Pound for pound the 550 is better than anything I've seen. It has great power for its size and can really hunker down and lug. Classified as a 3-bottom plow depending on soil conditions. I personally don't think it can be beat for a utility tractor in the 40 HP range. They are extremely thrifty on fuel, at least my DSL is. Most drive train parts are fairly easy to get. Sheet metal is probably the hardest thing to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
