Posted by Steve@Advance on August 28, 2021 at 05:46:29 from (173.11.197.117):
In Reply to: 86 Ford 4x4 F 350 posted by 37 chief on August 27, 2021 at 20:40:21:
I've done several over the years.
No really special tools required, but they make things easier. A press and the tools for pressing bearings on and off is needed.
There are several different designs, some are more difficult than others, especially the ones with the carrier is shimmed and no adjustment nuts. The housing needs to be spread and the proper shims installed. The shims are ground plates, not cut out of shim stock, so you need an assortment of shims or have to guess, sourcing and buying them to get the right combination.
It is not a job for a novice! Everything must be right for it to run quiet and have a long life. New gears are more forgiving, every time I tried reusing old gears, it howled.
The easiest and most economical route is to find a good used one, clean it up, check it out, replace the pinion seal, but don't dismantle it.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
