Posted by showcrop on September 13, 2021 at 04:18:24 from (75.68.37.174):
In Reply to: YTDOT posted by Lynerd on September 12, 2021 at 16:16:46:
Quoting Removed, click Modern View to see
dlbuck, my take on it, and the way that I post about it is that YT replies to posts about hauling or trucks, are far, far more picky about things like load securing than real DOT inspectors are. One common one is that if anything loaded on a truck or trailer that has wheels on it that it has to be secured by chains instead of load straps, which is false. This situation is exacerbated by primarily new posters asking about how to transport, load, and secure their tractor on a trailer. They will get many incorrect answers, and the most common one is how far someone hauled a ten thousand pound tractor on a car carrier trailer behind a 1/4 ton pick-up truck with no problem. If it can be done it has to be correct right? The correct answers are easily found at FMCSA under load securement. I and a very few others here will answer these questions with the response that YT is the absolute worst place to ask these questions because those answering think they know but their information is heresay and is not from FMCSA.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.