Posted by 2SteveWI on September 23, 2021 at 12:35:54 from (104.243.232.125):
Have been working on my White 2-105 off and on for the last couple months. Bought this tractor a couple years ago at a consignment auction. The only other bidder on the tractor was the owner as I later found out. Tractor has always had low pressure. After buying a White service manual for the hydraulics and with lots of help from the YT community, I started testing. Based on flow from the case drain, we determined that the pump was worn. Took off the pump and dropped it off at a local Amish hydraulic shop that was well recommended. It was not cost effective for them to rebuild pump but they found a rebuilt pump for $1200. Put the pump back on and still had low pressure. Removed the pressure control valve and had to weld a nut on the stripped pipe plug for high pressure gauge. There were no shims on high pressure relief so added .060. Did the low pressure test and the leak off line test. Started up the tractor and the leak off line started blowing large volumes of oil over shop floor and ceiling. It also blew up my 0-300 gauge on the low pressure port. Took apart the pressure control valve and compared it to manual. Found the low pressure spool was in backwards. Reassembled correctly and added .030 more shims to high pressure relief. Works good now. Thanks to everone that gave advice, and shared their experience. Hope this helps someone else. My thought is that my pump was worn but not bad and someone tried looking at it without benefit of a manual. Steve
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
