Posted by Donald Lehman on September 29, 2021 at 09:30:51 from (74.78.242.235):
In Reply to: Heating with wood ? posted by Bruce from Can. on September 29, 2021 at 07:40:50:
I hear you Bruce. When I was farming it always seemed that we were cutting firewood the day we needed it. I had a combination furnace at the time. Sometimes it seemed like it took more fuel oil to get the green wood to burn than if we just used fuel oil Those were the days. Up to ten years ago (I'm 71 now), we tried to burn as much wood as possible and as little fuel oil as possible. With my wife fully retired now, cutting wood doesn't go too bad, but we find ourselves using a bit less wood and more fuel oil and NG. We use a combination of a oil furnace, a wood furnace piped into the air duct system, and a NG fire place in the living room. Had the house weatherized a couple of years ago and the reduction in wood and other heating sources required was noticeible. Used to get up every night to fire up the furnace. Now unless it's really cold, we fire it up at sack time, forget about it, and let the oil furnace take over.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
