Posted by John T on September 29, 2021 at 10:51:36 from (45.16.200.171):
In Reply to: Heating with wood ? posted by Bruce from Can. on September 29, 2021 at 07:40:50:
Having lived in several older farm homes over a span of some fifty or so years, Ive had the fortune or MIS fortune lol of heating with: Wood,,,,,,Wood Chips,,,,Corn,,,,,,,,Coal,,,,,,LP Gas,,,,,,,Natural Gas,,,,,,, Electric Resistance (really made my meter spin wore out the bearings lol very expensive) ,,,,,,,Heat Pumps,,,,,,,and can say coal was the warmest, followed by wood, followed by wood chips HOWEVER Heat Pump heat is coldddddddd heat brrrrrrrrrrrr like to froze to death.
Now I have Dual Fuel consisting of a Heat Pump (also AC) when its above 45 Degrees but below a High Efficiency Natural Gas Furnace which (until price rises grrrrrrr thanks Joe) is very cost efficient. As my age increases Im NEVER going back to coal or wood or corn and am very warm n toasty and well satisfied with my Dual Fuel options. If I were much much younger just starting out Id invest in super insulated smart home technology and use a variety of Passive Solar, Earth Sheltering, Geo Thermal, Solar and Wind Energy to get far off of and less dependent on the grid as possible.
Have a nice day yall and for those so inclined please pray for our Country and the border crisis, Americans left behind and stranded in Afghanistan, the rising crime and murder in big cities and rising prices and inflation grrrrrrr
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
