Posted by used red MN on September 30, 2021 at 22:30:50 from (75.73.112.20):
In Reply to: Farmall M posted by 37 chief on September 30, 2021 at 20:32:44:
A 400 was designed to be equipped with a live PTO and, live hydraulics with integral valving and a Torque Amplifier. On the M & MD or the Super models these items were added on to modernize that tractor line. The 400 did have a little bigger engine than the MD 248 vs 264 CID, but was the same as the Super MD. The x00 series introduced the fast hitch on models over 30hp. I can not tell you if there will be damage to the diesel injection pump if it is run for longer periods on gas, I do not think it will. The thing about it is the gasoline start system is only designed to start the engine and warm it up to switch to diesel. The carb and intake system for the gas side is small and really only designed to run the engine at a fast idle and the tractor will only have minimal power on gasoline. I will attach a link to the tractor data page for the 400 so you can see the physical difference between it and your MD.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
