Posted by caterpillar guy on October 23, 2021 at 08:14:35 from (47.26.95.42):
In Reply to: Nice old barn posted by larry@stinescorner on October 23, 2021 at 05:19:57:
Geo. You say no way to reuse them. There are several around here they opened them up for machinery. Room for combines and sprayers in them. My brother has opened one up to use for a shop with a 16ft high door and 24 wide. He cut the old mow out put 2, 1/4x4 inch angles up the opposite corners of the timbers to hold them with the angles in the cement floor. Then put 2x8or 10's from the eaves up to the middle of the peak from each side bolted to together at the peak and bolted to the timber going up to the purlin plate at the hip this holds it from shifting sideways then the old braces in the lower portion of the barn hold it endways with a couple new braces he put in. For the crosswise holding between the walls we put 3or 4 Steel beams across from one side to the other and welded a steel plate on to the steel beam at the timber at the eaves. These are bolted down through the timber holding the walls from moving in or out. On the timbers coming down from the hip I welded an angle on in line with the vertical to hold the timber on top of the steel beam and is bolted to the angles. We had the sprayer there with a hose and water for fire prevention and soaked the wood down some where I was welding so the wood was wet before welding. On dad's the back side of the mow wall was opened up so we can put round bales in up to the hip all across the barn will hold about 160-200 4x4 round bales when put in. We put them in 5 high where we clear the roof with them.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.