Posted by ratface on November 22, 2021 at 10:02:38 from (23.120.126.211):
Now that I got your attention, this is not about a wife, truck or tractor, but rather a car. The backstory: In 2021 I bought a new Kia Soul Ex. Good price point, lots of standard amenities and just a comfortable fun little car to drive.
Last week at 8000 miles the automatic transmission needed replacing. Kia honored the warranty and I already have the vehicle back with a remanufactured transmission same model as the one which failed. The tech said they have so many failures that KIA rebuilds the old defective units. As far as I know it is identical to the failed unit without improvements. I have lost confidence in the car because I see no reason for it not happening again. In addition this model year is also prone to engine failure to what degree I do not know. I am looking for your perspectives, knowing there are bound to be some service techs lurking here with inside information, how common is this in the auto industry, was it a poor installation during the build or have you had a similar experience with your vehicle, did you stay or go?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
