Posted by docmirror on November 28, 2021 at 10:51:39 from (75.3.255.251):
In Reply to: Let's talk hydraulics posted by grandpa Love on November 28, 2021 at 07:50:41:
Quoting Removed, click Modern View to see
After looking at the end of the cyl again, I think Geo is right on this might be a wire lock type. Clean the end out with a small wire brush and some varsol. You will see a round wire ring, with a gap like a piston gap. Need a very small, very good curved pick to get the end of the wire out of the gap. May need to press down/in on the flange to get the wire out of the gap. Once the wire is out, the lock flange and bushing will come up. If it's stuck, I use a come-a-long on the shaft to pull the flange, bushing, seals out.
I have seen an old one that used a huge snap ring, but that was on a 1940s cylinder and it was very heavy bore, with a thick snap ring.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
