Posted by BarnyardEngineering on November 30, 2021 at 08:21:21 from (161.69.121.34):
In Reply to: Chain saw dressing posted by 550Doug on November 30, 2021 at 06:11:36:
If you're fairly new to serious chain sawing what makes you think you need to dress the bar at this early stage? Unless you bought a used worn out bar for your saw, you should not be anywhere near needing to dress the bar.
It really sounds like you're watching youtube videos or reading forum posts and getting ideas in your head without the complete story.
The bar is designed to be flipped over to double its longevity, so you want to run it with the bar flipped for exactly 50% of the bar's life. There are 100 ways to go about it. You can be super-obsessive and flip the bar each time you sharpen the chain. You can be casual about it and flip the bar each time you install a new chain. You can be neglectful about it and only flip the bar when one side is slap wore out. Or anywhere in between. It's your saw and whatever way you choose is the right way.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
