Posted by OldCaseNewman on December 18, 2021 at 17:03:57 from (174.247.146.244):
In Reply to: tin roof condensation posted by 37 chief on December 18, 2021 at 14:06:24:
Condensation is from the difference in temperature between the two sides of the outside layer over the insulation. Increasing insulation reduces that difference by reducing the temperature of outer part of the insulation and keeping the heat away from the tin or whatever is in the outside. So the best way to reduce condensation is adding insulation. In dry regions, increasing air exchange between inside and outside air reduces interior air moisture but heat exchangers heat incoming air with outgoing air, reducing the moisture added to the air from bathrooms and kitchens. In Montana we consider 6 of insulation the bare minimum in a roof that has insulated rafters, but ten inches would be the least I would use to prevent condensation.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
